Num'axes PIE 1013 Guide D'utilisation page 41

detected and remains within the sensor's range.
In PIR detection mode, the Time Out can go from 5 seconds (00:05) to
60 minutes (60:00).
•
After pressing [M] to confirm the Burst Shoot or Video Length
setting, "CAM" and "T-O" or "VIDEO" and "T-O" will be blinking
on the status display.
•
Press [M] to enter the Time Out setting.
•
The minutes 1
button to increase or decrease the value then press [M] once to
confirm and move to the next digit setting.
•
The minutes 2
button to increase or decrease the value then press [M] once to
confirm and move to the next digit setting.
•
The seconds 1
button to increase or decrease the value then press [M] once to
confirm and move to the last digit setting.
•
The seconds 2
button to increase or decrease the value then press [M] once to
confirm the Time Out setting.
•
You'll then see the word "PIR" blinking on the LCD screen. Press
the DOWN [▼] button twice to enter the SET menu or press and
hold the [M] button for 2 seconds to exit.
Setting the Time Lapse Mode (TLS)
In Time Lapse mode, the camera will take photos automatically at your
choice of intervals during one block of time you set up.
The Video mode is not available in Time Lapse mode.
The Time Lapse default settings are the following:
•
Block of time: 19:00 to 07:00 the next day
•
Time Out: 60 seconds
•
Image resolution: 8MP
•
Burst mode: 1 image per trigger
Outside of the Time Lapse time frame, the camera will follow the user
Indice A
st
digit is blinking. Press the UP [▲] or DOWN [▼]
nd
digit is blinking. Press the UP [▲] or DOWN [▼]
st
digit is blinking. Press the UP [▲] or DOWN [▼]
nd
digit is blinking. Press the UP [▲] or DOWN [▼]
41/144