Num'axes PIE 1013 Guide D'utilisation page 45

button to increase or decrease the value then press [M] once to
confirm and move to the last digit setting.
•
The minutes 2
button to increase or decrease the value then press [M] once to
confirm and move to the date setting.
•
The letter "D" (Date) is blinking. Press the
[M] button once to enter the date setting
(YY/MM/DD).
•
Adjust the Year, Month and Day using the UP
[▲] or DOWN [▼] button. Each time you finish an adjustment,
you must press the [M] button to confirm and move to the next
digit setting.
•
Once done, the word "GPS" will be blinking on the LCD screen,
this stands for coordinates value setting. Press the [M] button
once to enter the GPS coordinates setting or press and hold the
[M] button for 2 seconds to exit and go back to the status screen.
Setting up the GPS coordinates
Your camera can be programmed to trace the image location. The GPS
coordinates will be shown in the image file properties.
NOTE: The latitude and longitude for any location where you
plan to place the camera can be obtained at many websites,
e.g. www.itouchmap.com/latlong.html.
•
After pressing [M] to confirm date setting, the word "GPS" will
be blinking on the LCD screen.
•
Press [M] once to enter the GPS coordinates setting.
•
The indication "LAt" will be blinking on the LCD
screen. Press [M] once.
•
The "+" sign is blinking on the LCD screen. Press
the UP [▲] or DOWN [▼] button to select "+"
for North or "-" for South. Then press [M] once to confirm and
move to the latitude 1
•
The latitude 1st digit is blinking. Press the UP [▲] or DOWN [▼]
Indice A
nd
digit is blinking. Press the UP [▲] or DOWN [▼]
st
digit setting.
45/144