Morphy Richards Redefine Mode D'emploi page 11

Sound
The audible signals from your Hot Water Dispenser can be
turned on or off. Press and hold the Temperature Button (4)
for 2 seconds to switch the sounds on or off.
Standby
Your Hot Water Dispenser will enter Standby Mode to
save power 60 seconds after the end of the heating and
dispense cycle. The unit enters standby mode after 30
minutes of inactivity if a heat and dispense cycle hasn't been
completed. To wake the unit, press any button or rotate the
Water Volume Dial (2).
The Hot Water Dispenser can be placed in standby mode by
pressing the Start/Stop Button (1) for 2 seconds.
Any water remaining in the Heating Chamber when your Hot
Water Dispenser enters stand by will need to be dispensed
upon exiting standby, or reheated and dispensed before a
new volume or temperature can be selected.
Drip Tray
1 6
The Drip Tray Indicator (10) indicates that the Drip Tray (8)
is full and must be emptied. To empty, pull the drip tray
outwards until it is free from the runners and
discard the contents. CAUTION! The contents of the drip tray
may be hot. Replace the Drip Tray once emptied ensuring
the Drip Tray Cover (9) is replaced correctly.
Descale
1 7
This product is fitted with a concealed element that must be
descaled when the Descale Icon (16) illuminates. Excessive
scale can cause the product to switch off before the end of
the heating cycle and may damage the element invalidating
the warranty.
Remove hard scale using a proprietary descaling product.
We recommend Oust Descaler (please follow the instructions
carefully) which may be purchased from our Helpline or from
your local retailer.
To descale the unit:
1 Remove the BRITA Hopper (21) and MAXTRA cartridge
(19) from the Water Tank (7).
2 Fill the Water Tank to the MAX line with cold water add
the Oust Descaler as per manufacturers instructions.
3 When the crystals have dissolved, set the unit to heat
1.5 litres of water to 85 degrees.
Donotboilto100degrees
4 Leave the Hot Water Dispenser for 10 minutes.
Donotdispensethewater!
5 After 10 minutes, dispense the water from the Heating
Chamber into a vessel and discard.
6 Empty the water tank and rinse thoroughly with cold
water.
7 Fill the water tank to the MAX line with cold water, set
the unit to boil 1.5 litres to 100 degrees and dispense
the water. Discard the water and repeat the cycle 3 times
8 Replace the BRITA Hopper and MAXTRA cartridge into
the Water Tank. Fill with fresh water.
9 Press and hold the Start / Stop Button (1) and Dispense
Button (5) for 5 seconds to reset the descale time. The
descale icon will extinguish. The Hot Water Dispenser
will reset and the unit will return to ready mode.
10 After 60 seconds of inactivity the Hot Water Dispenser
will enter standby.
Cleaning
Wipe the outside with a damp cloth.
WARNING:Alwaysdisconnecttheplugfromthe
mainsandallowtheappliancetocoolbeforecleaning.
IMPORTANT:Donotuseabrasivecleanersonthe
outsideoftheappliance,astheymayscratchthe
surface.

g

f

d

e

i

q
∂ 
t