Morphy Richards Redefine Mode D'emploi page 10

To pause the water flow whilst dispensing, press either
11
the Start/Stop or the Dispense Button.
To resume the water flow, press the Dispense Button
12
again.
NOTE:You must dispense all water heated before you
can start the heating cycle again.
Drinks Temperature
Getting the correct water temperature is essential if you are
to enjoy your favourite hot drinks with maximum flavour and
taste.
By choosing the correct temperature for your drink, not only
will you create better tasting drinks, you will also save time
and energy too.
85°C
Green, white and herbal teas, powder based cold and flu
remedies, black instant coffee.
95°C
French press/cafetiere coffee, instant coffee with milk, hot
toddies, malted milk, hot chocolate.
100°C
Black teas e.g. darjeeling, assam, ceylon, english breakfast
and earl grey, noodle / pasta snacks, instant soup type
drinks.
Auto/Manual Dispense
The auto dispense feature allows you to automatically
dispense volumes of water below 600ml. For safety reasons
it is not possible to automatically dispense volumes above
600ml.
Before heating, press the Dispense Button (5) to switch the
auto dispense feature on or off. The Icon (14) will
appear on the LCD Screen (3) when the feature is enabled.
After heating, if the volume is above 600ml, or if the auto
dispense is turned off, your Hot Water Dispenser will sound
and the Dispense Button will Illuminate. Press the Dispense
Button to begin dispensing water from the Dispense Nozzles
(6).
NOTE: All water must be dispensed before you can start the
heating cycle again.
10
Multiple Cups
Multiple cups can be filled quickly and easily by starting and
stopping the dispense cycle and exchanging vessels.
1 Set your Hot Water Dispenser unit to heat a desired
amount of water with the Auto Dispense featue
switched off. Place two cups under the Dispense
Nozzles (6) and dispense the water by pressing the
Dispense Button (5).
2 When the cups are filled press the Dispense Button
again to stop the flow.
3 Place another two empty cups under the Dispense
Nozzles and repeat the process until all remaining water
has been dispensed.
Dispense Nozzles
There are two Dispense Nozzles (6) on your Hot Water
Dispenser. These can be used to fill one or two cups at one
time.
1 5
If dispensing into two vessels try to ensure they are of equal
size and heat double the amount of water
required for one. Place your cups on the Drip Tray
(underneath the Dispense Nozzles).Your Hot Water
Dispenser will dispense an equal amount from each Nozzle.
Cancel the heating cycle
To cancel the heating cycle at any time, press the Start /
Stop Button (1). Press either the Start / Stop Button again to
continue the current cycle or press the Dispense Button (5)
to empty the water.
Once a heating cycle has begun, the volume and
13
temperature of the water can only be changed during the
first few seconds of the heating cycle.
The Water in the heating chamber must be dispensed before
a new volume can be selected.
Reheating Water
Any water remaining in the heating chamber that has cooled
down by 5 degrees can be reheated.
The Start / Stop Button (1) will illuminate and the
Heat Icon (11) will extinguish indicating the reheat
function can be activated. Press the Start / Stop Button to
reheat.
1 4