Removing And Cleaning The Brushes - SEVERIN RB 7028 Mode D'emploi

10 Cleaning and care
38
39

10.2 Removing and cleaning the brushes

40
On the suction inlet (on the underside of the appliance) there
are 2 sensors which respond when the suction inlet is heavily
soiled (fig. 38).
If this is the case, clean the suction inlet thoroughly, for ex-
ample, with a vacuum cleaner.
When inserting the dust bin and the cover, make sure that the
sensors trigger (fig. 38).
5. Fit the cover (fig. 39).
1. Make sure that the appliance is switched off and the
mains adapter is not connected.
2. Carefully place the appliance on its head so that the un-
derside is accessible.
3. Detach the brushes as indicated (fig. 40).
4. Remove hair and dirt from the brushes. If necessary,
carefully use a scissors or tweezers to do so.
5. Rinse the brushes off under water.
6. Remove hair and dirt from the brush mount.
7. Re-attach the brushes.chapter „Fitting the brushes",
page 55
TIP: If the bristles are bent, the brushes can be soaked in hot
water so that they return to their original shape.
75