Cleaning And Ordinary Maintenance - Bonnet Neve SHAPE Instructions Pour L'utilisateur

Modello - Modèle - Model
Modell - Modelo - Modelo
Fabbricante - Constructeur - Manufacturer
Hersteller - Fabricante - Fabricante
Inclination of the display shelves
IT
The rear panel inside the cabinet protrudes in
some points so that the display shelves can be
FR
inclined in different positions.
10.9 Cleaning and ordinary
EN EN
maintenance
DE
Good visibility in the intervention area is
recommended, possibly using an additional light
ES
source.
In the presence of front glass on the cabinet, it
PT
is recommended
operations when there is no customer in the
sales area.
Cleaning the cabinet
Only use water at a maximum temperature of
65°C and household soap or neutral detergent
diluted in water.
For glass surfaces use only products for cleaning
glass. It is recommended to avoid the use of
water since it may deposit limestone on the
surface of the glass.
• Abrasive sponges
• Flammable or abrasive products such as
alcohol, acetone or solvents
• Detergents
surfactants, lemon or vinegar (acetic acid)
F Do not wash or clean the top part of the
cabinet with water or liquids.
Wastewater from
defrosting and/or cleaning) should be delivered
through a sewage system or sewage treatment
plant compliant with current laws.
Clean all the external parts of the cabinet ONCE
A WEEK.
Clean all the internal parts of the cabinet ONCE
A MONTH, following the instructions below:
• Disconnect the power supply to the cabinet
using the wall-mounted main switch-
disconnector ("Fig. 34").
• Empty the cabinet, storing the goods in
cold rooms or refrigerators to maintain the
preservation temperature.
N°DOC. UM000303 REV. "H" - 31/01/22
to carry out cleaning
that contain non-ionic
the cabinets (following
SHAPE
Epta Spa - Via Mecenate, 86 - 20138 Milano (MI) ITALIA
Tel. 02/55403211 Telefax 02/55401023
• Wait for the inside of the cabinet to have
reached the ambient temperature and
then clean
• After carefully checking that the inside of
the cabinet is completely dry, restart the
appliance by re-energising the cabinet.
• After a couple of hours, load the goods
again.
To facilitate cleaning operations the following
have been provided for:
• A drain that conveys the water used for
internal cleaning directly to the outside of
the cabinet.
• Easily removable air delivery cavities.
• A fan holder that can be rotated upwards
("Fig. 36").
Defrost the cabinet EVERY THREE MONTHS to
allow the ice to melt which may have formed on
the fins of the evaporator preventing correct
operation. The duration of the defrosting activity
is regulated directly in the factory. Any
adjustments are reserved exclusively for the
technical service department. The defrosting
water is collected by a special drain and
conveyed to a dissipation bowl placed at the
bottom of the cabinet. Periodically check that
the defrosting water drains normally. If not,
intervene immediately using a non-pointed
flexible probe.
Do as indicated to clean the internal parts
MONTHLY, but in this case foresee a longer
waiting time to allow the ice to melt completely.
22/25