Frequency Measurement; Temperature Measurement - KPS MT50 Manuel D'instructions

KPS-MT50 • Digital multimeter
unit of capacitance is the farad (F). Most capacitors are in the nanofarad to
microfarad range. The Meter's capacitance ranges are 40,00nF, 400,0nF,
4,000μF, 40,00μF ,400,0μF y 4000μF.
To measure capacitance:
1 Set the rotary switch to
ativate Capacitance Test.
2. Connect the black and red test leads to the COM and terminals respectively
(or you can measure the capacitance by using the special Multi-Function
Socket).
3. Connect the test leads to the capacitor being measured and read the
displayed value.
3.2.6 Transistor measurement
1. Set the rotary switch to hFE position.
2. Connect the "com" plug and "+" plug of the special multi-function socket to
the COM and hFE terminals.
3. Determine whether the transistor to be tested is NPN or PNP type and locate
the Emitter, Base and Collector leads.
4. Insert leads of the transistor into proper holes of the special multi-function
socket.
5. The meter will show the approx. hFE value at test condition of base current
10μA and Vce 2.8V.

3.2.7 Frequency measurement

Frequency is the number of cycles a voltage or current signal completes each
second.To measure frequency:
1. Set the rotary switch to Hz % position.
2. Connect the black and red test leads to the COM and Hz terminals
respectively.
3. Connect the test leads to the circuit being measured
4. Read the displayed value.

3.2.8 Temperature measurement

To measure temperature:
1. Set the rotary switch to TEMP position.
2. Connect 'K' type thermocouples to terminals.make sure the red and balck
leads to the TEMP and COM terminals respectively
position.Press the FUNC key three times to
35