KPS MT50 Manuel D'instructions page 30

The Meter is in the Data Hold mode
C: Celsius scale. The unit of temperature.
ºC or ºF
F: Fahrenheit scale.
V: Volts. The unit of voltage.
V, mV
mV: Millivolt. 1x10-3 or 0.001 volts.
A: Amperes (amps). The unit of current
A, mA, μA mA: Milliamp. 1x10-3 or 0.001 amperes.
μA: Microamp. 1x10-6 or 0.000001 amperes
Ω: Ohm. The unit of resistance
Ω, kΩ, MΩ kΩ: Kilohm. 1x103 or 1000 ohms
MΩ: Megohm. 1x106 or 1,000,000 ohms.
Hz: Hertz, the unit of frequency
MkHz KHz: Kilohertz. 1x103 or 1000 hertz.
MHz Milohertz, 1 x106 or1000000 hertz
F: Farad. The unit of capacitance.
μF, nF μF: Microfarad.1x10-6 or 0.000001 farads
nF: Nanofarad. 1x10-9 or 0.000000001 farads.
2.3 Keypad
Table 2. Keypad
"FUNC" key is the function select key that acts with trigger.
FUNC
Use the key as switch of DC/AC, Resistance/Continuity/
Diode/capacitance and ºC / ºF.
Press "HOLD" to enter and exit the hold mode in any mode.
That act with trigger. When press and holding this key for more
than 2secs , the meter is switched to the back light mode.
KPS-MT50 • Digital multimeter
30