Reflect Mount Using Spacer Bar - Siemens SITRANS F FST020 IP65 NEMA 4X Instructions De Service

Connecting
3.3 Installing the Sensor
3.3.1

Reflect Mount using Spacer Bar

The spacer bar eliminates manual spacing measurements and provides rigidity for mounting
the sensors while maintaining axial alignment. Refer to Programming the Transmitter
(Page 17) before proceeding.
1. Perform all required menu steps taking note of the sensor model and size designation.
Note
Note the number index value displayed in the [Install Sensor] menu. You will use this
index to properly space the sensors. Check to ensure that you have a matched set of
sensors. They both should have the same S/N number but marked with either an "A" or
"B" (e.g., 19256A and 19256B).
2. Prepare the pipe surface area where the sensors will be mounted. Degrease the surface
Note
Before beginning refer to the Reflect Mount sensor installation diagram below.
26
The transmitter then issues the number index and prompts you to press <ENTER> to
finish the sensor install routine. Stop at this point.
and remove any grit, corrosion, rust, loose paint, etc.
①
Optional: On larger pipes, multiple
lengths of straps can be linked together
to surround pipe
②
Mounting Strap positioned around
Mounting Frame
③
Sensor shown in the 9 o'clock position on
pipe
④
Mounting Frame
Figure 3-6 Reflect Mount with Mounting Frames and Spacer Bar
⑤
Space Bar Platform & Clamping Screw
⑥
Space Bar (Front View)
⑦
Metal Post
⑧
Mounting Strap Adjusting Screw
FST020 IP65 NEMA 4X Quick Start
Operating Instructions, 03/2012, A5E03086489-05