Steam Nozzle; Drip Basin; Emptying Used Coffee Grounds; Water Tank - Caple CM461 Mode D'emploi

Steam nozzle

GB
In addition, periodically clean the steam nozzle, which
can get dirty inside when you warm milk for cappuccino.
To do this, just disassemble it as shown in the figure
and wash it together with its hood with a sponge and
hot water.
ATTENTION: when cleaning the nozzle, always
turn off the machine and remember to wait at
least 20 minutes before using it to allow it to
cool, avoiding possible burns.

Drip basin

Remove the drip basin from the machine as shown in the
following figures.
Make sure to periodically empty the basin to avoid
liquid spills that could dirty and ruin the furniture below.
The basin and relative metal grill can be washed in the
dishwasher.

Emptying used coffee grounds

To open the door of the compartment with the tray, you
must first remove the drip basin as described in Figures
16.4 and 16.5.
ATTENTION: avoid emptying the grounds
collection tray with the machine on to avoid
accidental contact with hot parts.

Water tank

• If the machine has not been used in a long time, we
recommend changing the water in the tank
• Periodically clean the water tank of any lime
encrustations.
• The tank can be washed in the dishwasher.
• If using the Brita decalcifying filter, we recommend
replacing the filter every 2000 espresso coffees or at
least every three - six months.

17. TROUBLESHOOTING

The operator should make sure that the problem is not
caused by:
- No electricity
- No water in the tank
- No coffee in the machine
- Incorrect closure of the access door to the coffee
ground tray.
For any other causes, have the machine checked by
Caple Service, tel 0844 800 3830 or email
service@caple.co.uk .
30
Remove the tray, empty the
coffee grounds and wash
it with hot water or in the
dishwasher.
Put the "used" coffee ground
tray back in its compartment.