Yakima HoldUp Plus2 Mode D'emploi page 2

ReMOve eNd cAP
fROM hOlduP.
Using a flathead screwdriver, remove
the end cap from the HoldUp.
INsTAll MAIN BOlT.
75 ft-lbs.
ReMOve fAsTeNeRs.
1034431G-2/21
INseRT Plus2 BAse INTO hOlduP.
Align
• Squeeze knob to release lock.
• Insert bolt,
• Pull spring pin to release base.
and lock-
• Lift frame.
washer in
• Release spring pin. Pin should snap into place
order shown.
• Tighten with
adjustable
wrench.
The fasteners are installed in the trays for shipping
purposes. Remove them to prepare for assembly.
ROTATe TO uPRIGhT POsITION.
and lock.
Insert the Plus2
base into the
HoldUp tube,
aligning holes.