Pando PHT-941 Manuel D'utilisation page 91

INOXPAN S.L.
3. Switch the oven on, turning the left dial to select the
4. An audible signal will be heard confirming that the SCS feature has been activated.
On the screen the
The duration time is pre-set to 24 minutes.
The duration of this cycle cannot be changed. To stop before the completion of the cycle, turn the
oven off by pressing the button
5. When the cycle ends, the oven will turn itself off, an audible signal will sound and the
flash quickly .
Do not open the oven door until the SCS cycle has ended completely.
The cooling cycle is necessary for this feature to work properly.
6. Press any button with your fingertip to stop the audible signal and to turn off the
7. The oven will turn off automatically.
8. The oven is ready for dirt deposits and excess water to be removed with the cloth.
The SCS feature works at low temperatures. However, cooling times can vary according to room
temperature.
Before touching the inner surface of the oven directly, make sure that the temperature is not too hot.
If a deeper clean is required after running the SCS feature, use neutral detergents and non-
abrasive sponges.
symbol will appear as will the remaining time the cycle needs to finish.
.
function and confirm with the
EN - 19
button
symbol will
symbol.