American Standard INAX SpaLet Manuel D'installation Et De L'utilisateur page 14

5. Install the remote control unit
* For Remote Version Only
(1) Open the back cover of the
remote control unit and insert the
2 size AA batteries.
CAUTION
• Insert each battery so its positive
pole touches a positive connector
in the battery compartment and its
negative pole touches a negative
connector.
(2) Position the bracket on the wall
in the location you chose for
the remote control unit. Mark the
location of the mounting holes on
the wall. Fasten the bracket to the
wall, drilling holes and using the
fasteners appropriate for the wall
material, as described below.
CAUTION
• Leave enough space above the
top of the remote control unit to
allow the unit to be removed and
replaced.
If mounted in plywood paneling
0.20 in. (5 mm) or greater in
thickness:
Fasten the bracket to the wall with the
mounting screws.
Back Cover
Battery
14
Bracket
Mounting Screw