3. Installation of water supply hose to the bidet
Installation
Figure
Water supply
hose
3) Insert the attachment clip onto the
water supply hose to attach it to the
bidet and water supply connection
socket.
* The attachment clip can be attached in
any direction.
4) Bend the clip end and firmly clip
together both the feeding hose for
the bidet and the feeding socket.
After you install the clip, twist it in
both directions to verify that it is
firmly attached, then attach the
final attachment clip over the
primary clip to secure in place.
5) Insert the clip until you feel the clip
edge click.
* If not firmly inserted, it may cause
water leaks
Water supply
joint
Plastic
Clip
Clip
O-ring
12
1) Remove the protective cover
from the end of the water supply
hose, and pull out the cap from
the water supply connection
socket.
2) Connect the water supply hose
for the bidet to the water supply
connection socket.
WATER SUPPLY
CONNECTION SOCKET
Protective
Cover
Water supply
hose for
the seat
CAUTION
• B e careful not to damage the O-ring.
* A damaged O-ring may cause water to leak.
CAUTION
• F irmly insert the clip.
* If the clip is not firmly inserted,
it may cause water leaks.
Water
supply
socket
O-ring