PRASTEL EASYBKW Mode D'emploi page 11

EASYBKW
4. WIRING
The reader is supplied with a 6-conductor cable about 40 cm., to
connect the Reader, perform the following steps:
1) Prepare the Reader cable by cutting the cable jacket back 3 cm
and strip the wire 1,5 cm. Prepare the Controller cable at the
same way.
2) Splice the Reader pigtail wires to the corresponding Controller
wires and cover each connection.
3) If the tamper output is being utilized, connect the purple wire to
the correct input on the Controller.
4) Trim and cover all conductors that are not used.
5. TRANSMIT MODE
When the EASYBKW is in Transmit Mode, it is ready to receive data
from an entered PIN code.
In this mode the Transmit LED is red
and the Program LED is off.
During a code transmission the
Transmit LED will flash green. Keyboard data can be sent via one of
different Keypad Transmission Formats (see par. 6.3)
ENGLISH
COLOR
RED
BLACK
WHITE
GREEN
BROWN
PURPLE
11
OUTPUT
+VDC
GND
DATA1 / CLOCK
DATA0 / DATA
LED CONTROL
TAMPER
RED
.docx
ISEASYBKW_06_17