Checking Engine Oil; Changing Engine Oil - Mi-T-M Corporation GEN-3600-0MM0 Manuel De L'opérateur

EVAPORATIVE EMISSION COMPONENTS:
The unit you have purchased includes the following compo-
nents that are in compliance with California Air Resources Board
Evaporative Emission Standards;
1. Fuel Hose
2. Fuel Hose Fittings
3. Fuel Tank and Cap
4. Carbon Canister and Mounting Brackets
These components should be inspected on a daily basis for
cracks, leaks, and abnormal wear. If cracking, leaks or abnormal
wear has occurred, the components should be replaced immedi-
ately. Service should be done by authorized technician.
ENGINE:
The engine for this generator is governed to operate at speeds
close to 3600 RPM (60Hz) throughout the operating load range.
The no load speed (before a load is applied) will be just a bit
higher than the load speed and is normally set to 3750 RPM.
WARNING: DO NOT TAMPER WITH THE GOVERNOR
MECHANISM,
EXPERIMENTALLY, OR PUSH THE THROTTLE OPEN
IN AN ATTEMPT TO GENERATE MORE ELECTRICAL
CURRENT; EQUIPMENT
INJURY MAY RESULT.
GOVERNOR SPEED
MADE ONLY BY A MI-T-M CUSTOMER SERVICE
REPRESENTATIVE.

CHECKING ENGINE OIL:

Check oil level before each operation and ensure that it is main-
tained per Preparing the Generator; Engine Oil Capacity section.

CHANGING ENGINE OIL:

Change oil after the first 20 hours of operation. Thereafter it
should be changed every 100 hours.
1. Make sure the unit is on level ground. Run the engine to warm
the oil.
2. Stop the engine.
3. Remove the oil drain plug. (See Fig. 6)
CAUTION: OIL BEING DRAINED MAY BE HOT. TO
REDUCE THE RISK OF BURN INJURY, HANDLE WITH
CARE. DISPOSE OF USED OIL PROPERLY.
4. Drain oil while engine is warm, into a suitable container.
5. Reinstall the oil drain plug.
6. Remove oil gauge and refill with new oil. (Fig. 7)
7. Check the oil level as instructed in Preparing the Generator;
Engine Oil Capacity section.
8. Wipe up any spilled oil.
22 Operator's Manual
CHANGE THE
DAMAGE OR PERSONAL
ADJUSTMENT SHOULD
SERVICE
SETTING
BE
UPPER LEVEL
OIL DRAIN PLUG
(Fig. 6)
(Fig. 7)