Grounding Instructions; Preparing The Generator - Mi-T-M Corporation GEN-3600-0MM0 Manuel De L'opérateur

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

GROUNDING INSTRUCTIONS

This product must be grounded. If it should malfunction or
breakdown, grounding provides a path of least resistance for
electric current to reduce the risk of electric shock.
DANGER
-
IMPROPER
EQUIPMENT-GROUNDING
RESULT IN A RISK OF ELECTROCUTION.
WITH A QUALIFIED ELECTRICIAN OR SERVICE
PERSON IF YOU ARE IN DOUBT AS TO WHETHER
THE UNIT IS PROPERLY GROUNDED.
The wing nut and ground terminal on the frame must always be
used to connect the generator to a suitable ground source. The
ground path should be made with #8 size wire. Connect the ter-
minal of the ground wire between the two star washers and wing
nut then tighten the wing nut fully. Connect the other end of the
wire securely to a suitable ground source.
The National Electric Code contains several practical ways in
which to establish a good ground source. Examples given below
illustrate a few of the ways in which a good ground source may
be established.
A metal underground water pipe in direct contact with the earth
for at least 10 feet can be used as a grounding source. If a pipe
is unavailable, an 8 foot length of pipe or rod may be used as the
ground source. The pipe should be 3/4 inch trade size or larger
and the outer surface must be noncorrosive. If a steel or iron rod
is used it should be at least 5/8 inch diameter and if a nonferrous
rod is used it should be at least 1/2 inch diameter and be listed
as material for grounding. Drive the rod or pipe to a depth of 8
feet. If a rock bottom is encountered less than 4 feet down, bury
the rod or pipe in a trench. All electrical tools and appliances
operated from this generator, must be properly grounded by use
of a third wire or be "Double Insulated".
It is recommended to:
1. Use electrical devices with 3 prong power cords.
2. Use an extension cord with a 3 hole receptacle and a 3 prong
plug at the opposite ends to ensure continuity of the ground
protection from the generator to appliance.
We strongly recommend that all applicable federal, state and
local regulations relating to grounding specifications be checked
and followed.
LINE TRANSFER SWITCH
If this generator is used for standby service, it must have a trans-
fer switch between the utility power service and the generator.
The transfer switch not only prevents the utility power form feed-
ing into the generator, but is also prevents the generator form
feeding out into the utility company's lines. This is intended to
protect the serviceman who may be working on a damaged line.
THIS INSTALLATION MUST BE DONE BY A LICENSED
ELECTRICIAN AND ALL LOCAL CODES MUST BE
FOLLOWED.
Operator's Manual

PREPARING THE GENERATOR

CONNECTION
OF
CONDUCTOR
CHECK
THE
CAN
GND
34-0889
062104-ENG.
13

Publicité

Table des Matières
loading

Table des Matières