SOMFY ilmo 50 WT Notice page 31

Problems
The roller shutter The roller shutter locking system
does not stop in the upper position is not
when it reaches correct.
the upper end
limit position.
2. 4. 2. 5HVWRULQJ WKH RULJLQDO FRQ¿JXUDWLRQ
2. 4. 2. 1. Using the control point connected to the roller shutter
)ROORZ HDFK RI WKH  VWHSV LQ WKH SURFHGXUH FDUHIXOO\ WR FRUUHFWO\ UHVWRUH WKH RULJLQDO FRQ¿JXUDWLRQ
Place the roller shutter in the mid-height position.
1)
5HSHDW WKH QH[W VWHS  WLPHV LQ VXFFHVVLRQ
2)
Press the Up button until the roller shutter moves.
‡
Release the button immediately.
5HSHDW WKH QH[W VWHS WZLFH LQ VXFFHVVLRQ
3)
Press the Down button until the roller shutter moves.
‡
Release the button immediately.
Press the Down button again until the roller shutter
4)
makes 2 successive movements in the same direction.
7KH PRWRULVDWLRQ LV UHVHW WR WKH RULJLQDO FRQ¿JXUDWLRQ
‡
2. 4. 2. 2. Using the wired electronic motor setting tool
Press the Up and Down buttons on the setting tool at the
-
same time until the roller shutter makes two successive
up and down movements.
The drive has been restored with the original
‡
FRQ¿JXUDWLRQ
Copyright © 2007 - 2014 Somfy SAS. All rights reserved.
Possible causes Solutions
&KHFN WKDW WKH UROOHU VKXWWHU LV ¿WWHG
with end stops screwed onto the
ODVW VODW ¿[HG RU UHPRYDEOH VWRSV
incorporated in the runners or an end
slat acting as an end stop.
1
3
x 2
7s
Images not contractually binding
2
x 3
4
5