Power Set-Up; The Room Temperature Reaches The Temperature Fixed By The User; Burner Cleaning; Switching Off The Stove - Bio Bronpi Elsa Instructions D'installation, D'utilisation Et D'entretien

9.4.4.

POWER SET-UP

Press key P3 and the display D2 will start flashing. By pressing the key P3, it is
possible to modify the power of the stove according to the values available: power
1, 2, 3, 4, 5 or A (A= automatic combustion). After 5 seconds, the new value will be
saved and the display will return to the normal state (see drawing D38).
1 3 : 0 0
ESC
Mod
GS
9.4.6.

BURNER CLEANING

During the normal operation of the stove, there are automatic cleanins of the burner
each time set by Bronpi.
This cleaning lasts 150 seconds and consists in cleaning the rests of pellet placed
in the burner in order to make easier the operation of the stove. When this happens,
the display will show the following messages (see drawing D40):
9.4.7.

SWITCHING OFF THE STOVE

In order to switch-off the stove, simply press key P1 during a few seconds. Once
the stove is turned off, it starts the final cleaning phase in which the pellet feeder
stops and the smoke extractor and the tangential fan start working at maximum
speed. This cleaning phase will not stop until the stove reaches the appropriate
cooling temperature (see drawing D41 and D42). Meanwhile, the following
screens will appear:
ESC
9.4.8.

REIGNITION OF THE STOVE

Once the stove is turned off, it is not possible to reignite again until a safety time
has elapsed and the stove is cold enough. If you try to ignite the stove again and
it is not cold enough, the display will show the information on drawing D43 but the
stove will not ignite again until it is cold enough. Then, it will turn on normally.
1 5 : 0 5
ESC
GS
INSTALLATION, OPERATING AND SERVICING INSTRUCTIONS
9.4.5.
THE USER
When the room temperature reaches the value fixed by the user or the smoke
W
temperature reaches a value too high, automatically, the stove starts working at a
lower power. The stove modulates. See drawing D39.
D39
O F F
3 22
GS W
2 0
9.4.9.
Drawing D44 shows the information of the display when the stove is switched off.
W
D44
ESC
THE ROOM TEMPERATURE REACHES THE TEMPERATURE FIXED BY
ESC
1 3 : 0 0
ESC
3 22
D41
ESC

STOVE SWITCHED OFF

35
1 3 : 0 0
5 20
GS W
1 3 : 0 0
PCLr
GS W
GS W
D42
r e C
3 : 2 0
GS W
D38
D40
D43
ELSA