Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
5. Push the dust removal attachment forward until it is in contact with the socket cutter and then secure it
in this position by sliding the locking ring toward the socket cutter.
6. Check that the dust extractor is free to rotate relative to the diamond core drilling machine.
6.5
Selecting the speed
CAUTION
Risk of damage! The product is faulty.
▶ Do not attempt to change gear while the machine is running. Wait until the product has come to a
standstill.
Set the selector switch according to the core bit diameter used.
▶ While using one hand to turn the core bit, set the switch to the recommended setting.
6.6
Fitting the water supply connection
ATTENTION
Hazard due to incorrect use! Incorrect use can result in irreparable damage to the hose.
▶ Regularly check the hoses for damage and make sure that the maximum permissible water supply
pressure (see "Technical data") is not exceeded.
▶ Make sure that the hose does not come into contact with rotating parts.
▶ Make sure that the hose is not damaged as the carriage advances.
▶ Maximum water temperature: 40 °C.
▶ Check the water supply system to ensure there are no leaks.
To avoid damage to the components, use only fresh water containing no dirt particles.
1. Connect the water flow regulator to the diamond core drilling machine.
2. Connect the water supply (hose coupling).
7
Types of work
WARNING
Damaged power cords are a safety hazard! If the supply cord or extension cord is damaged while work
is in progress, immediately disconnect the device and the cord from the electricity supply. Do not touch the
damaged part of the cord.
▶ Regularly check all supply cords. Replace defective extension cords. Have damaged power cords
replaced by a qualified specialist.
Use of a ground fault circuit interrupter (residual current device, RCD) with a maximum tripping current of
30 mA is recommended.
7.1
TPS Theft Protection System (optional)
The product can be equipped with the optional TPS theft protection system. If the product you own
is equipped with this function it can be unlocked and made ready for operation only though use of the
corresponding TPS key.
Enabling product
▶ Make sure that the product is connected to the electricity supply. The yellow theft protection indicator
flashes. The product is now ready to receive the signal from the TPS key.
*351007*
5
6
351007
English
9
Publicité
Table des Matières
