TECO 40 TOP Manuel D'utilisation page 100

- Position the wheel as shown in fig.16 and move the bead breaker shoe near the rim edge.
During the bead breaking operation, you are
advised to keep the turntable closed (locking
wedges towards the centre)
- Press the pedal
the bead breaker and detach the bead from the
rim. Repeat this operation on the other side of
the wheel. It may be necessary to break the
bead at several points to free it completely.
Release the pedal to reverse the motion of
the bead breaking shoe.
After detaching the beads, remove the old
balancing weights.
- Thoroughly lubricate the sides of the tyre
around the entire circumference of the lower and upper bead to facilitate demounting
and avoid damaging the beads (fig.17).
Acting on the turntable pedal (C fig.16) closes the clamps and may be dange-
rous (danger of hand crushing). During rim clamping, do not keep the hands
under the tyre.
100
WARNING
(fig.16) to operate
WARNING
C
User's manual
16
17