Cleaning The Appliance - Moulinex Soup&Co LM925400 Mode D'emploi

PRACTICAL GUIDANCE
• Make sure you have enough liquid to cover the Min
limit marker (Cf. Fig. 7). and take care not to exceed
the MAX limit marker engraved inside the jug (Cf.
Fig. 8).
• Some recipes may cause sudden overflowing, due
to the formation of bubbles, particularly when using
frozen vegetables. In this case, it is up to you to
reduce the quantities accordingly.
• Time and temperature information is flashing:
you can modify this information. Adjust the time
as required with the aid of the + (increase) and -
(decrease) buttons, depending on the ingredients
used and the amount to be made (see table of the
cooking times for soups in the recipe booklet).
• With the cooking basket (depending on model*)
you can steam cook (use P3 with 0.5 litres of water),
or for chunky soup recipes and cooking whole
ingredients such as meat, fish, vegetables at the
same time as your soup (use P1 or P2).

CLEANING THE APPLIANCE

• Do not immerse the appliance in water. Never put
the motor unit (A) under hot running water.
• Clean the jug immediately after use.
• Fill up the jug with 1 litre of hot water along with
2 or 3 drops of washing up liquid Only use the
recommended amount of water and washing up
liquid. An excess of washing up liquid creates more
foam and consequently can lead to overflowing.
• Use the Autoclean automatic program:
wash the bowl.
• Once the program has stopped, unplug the
appliance.
• Press on the trigger (d2) then remove the blender
jug (D).
• Place the jug on a flat surface.
• Unlock the lid by turning it a quarter turn clockwise.
Remove the lid with care.
• When the lid is cool, remove the carrier seal. To do
so, grip it between your thumb and index finger, then
pull to extract it. The seal dismounts without risk of
deterioration (Cf. Fig. 12).
• Finish cleaning the jug with the aid of a sponge.
• Rinse the inside of the jug and the lid under running
• At the end of the programs, the appliance
automatically keeps the recipe warm for 40 minutes
so it remains ready to be consumed. To stop
warming, simply press the OFF button.
• If you open the lid, press the trigger or remove the
jug, the warming process will automatically stop.
• When the program has started, you can stop the
appliance at any time by pressing the P button (2
beeps will sound). The program is then in pause
mode and you can restart it by pressing the P button
again or by pressing the OK button (a beep signal
will be emitted).
• If you choose the wrong program by mistake and
you wish to cancel it, press the OFF button for 2
seconds and that will allow you to restart the times
and the temperatures.
water.
• In the event of the heated part of the jug getting
extremely dirty, leave to soak for a few hours in a mix
of water and washing up liquid to help get it clean.
to pre-
9
• Use a damp cloth to clean the motor unit (A). Dry
it carefully.
• The detachable parts (lid, seal, measuring cap,
cooking basket) can be cleaned with a sponge and
hot soapy water.
• To preserve the appearance and service life of the
lid of your appliance, hand wash it. Do not use the
abrasive side of the sponge to avoid scratches.
• The removable blade is not dishwasher safe — wash
it under running water using a brush.
15
15
• Take care when cleaning the blades
(d3) in the blender jug and when you
empty the bowl as they are sharp.