Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
System Setup (continued)
1
Unpack equipment. Locate and identify parts shown in "Parts"
section. Connect by-pass valve, in/out adapter. Attach com-
ponents using mounting clips. Position system on a hard level
surface with access to inlet plumbing, drain and electric outlet.
NOTE: Make sure by-pass valve is in by-pass mode.
Mounting clip
2
Connect plumbing from the inlet supply to the inlet of the
water softener, then softener outlet to home's water supply.
NOTE: When using a sweat adapter, be sure not to solder plumbing
with adapter attached to equipment to prevent damage to plastic.
By-pass valve
In/out adapter
Inlet
Outlet
12
Publicité
Table des Matières
