Storing Your Iron; For Your Security - T-Fal FV92 Série Mode D'emploi

4- STORING YOUR IRON

- Unplug the iron and wait for the soleplate to cool down.
- Empty the water tank and set the steam control to DRY. A little water may remain in the tank.
- Wind the cord not too tightly around the heel at the back of the iron.
- Store the iron on its heel.

FOR YOUR SECURITY

• If it drops or falls on the floor, the iron must not be used if there is any visible sign of damage or if it leaks.
• Your iron must be placed on a flat and stable, heat-resistant surface.
• Warning ! The voltage of your electrical installation must correspond to that of the iron (120 V).
Connecting to the wrong voltage may cause irreversible damage to the iron and will invalidate the
guarantee.
• This iron must always be plugged into an earthed socket.
• If using a main extension lead, ensure that it is correctly rated (13A).
Cords rated for less amperage may overheat.
• If the electrical cord becomes damaged, it must be immediately replaced. Please contact T-FAL's Consumer
Service Department to avoid any danger.
• Never immerse your iron in water !
• The appliance must be unplugged before filling or emptying the water tank.
• If the appliance falls, have it checked by a suitably qualified person before using it again; unseen damage
may be dangerous.
• The soleplate may be very hot :
- Never touch it.
- Always let it cool off before putting it away.
- Never leave your iron unattended when it is plugged in or while the soleplate is still hot.
- Always keep your iron out of the reach of children.
- Be careful of hot steam especially when ironing close to the edge of the ironing board.
• When placing the iron on its stand, ensure that the surface on which the stand is placed is stable.
• NEVER DISASSEMBLE YOUR IRON ON YOUR OWN ;
PLEASE REFER ALL SERVICE AND TECHNICAL QUESTIONS TO T -FAL'S
CONSUMER SERVICE DEPARTMENT.
• This product has been designed for domestic use only.Any professional use, inappropriate use or failure to
comply with the instructions, the manufacturer accepts no responsibility and the guarantee will not apply.