T-Fal ActiFry express XL Manuel D'utilisation page 7

Problems Causes
You are not using a potato
variety that is recommended
for chips.
The potatoes are insuffciently
washed and/or not completely
dried.
The fries are not
crunchy enough.
The fries are too thick.
There is not enough oil.
The filter is clogged.
The fries break
The quantity is too large.
during cooking.
The food stays on The pan has too much food.
the edge of the
pan.
Max level exceeded.
Cooking liquids
Faulty pan or paddle.
have leaked into
the
base of the
The max level has been
appliance.
exceeded.
The appliance is not plugged
The LCD screen in.
does not work.
The lid is open.
The LCD displays The appliance is not
shows «Er» (error). functioning correctly.
You suspect there is a problem
The appliance
in the way the appliance
is abnormally noisy.
motor is working.
If you have any product problems or queries call our Customer Relations Team first for
expert help and advice:
Helpline: 1-800-418-3325
or contact us via our web site: www.t-fal.ca
Solutions
Choose a potato variety that is
recommended for fries such as Yukon Gold
or Russet potatoes.
Wash potatoes for a long time to remove
the starch, drain and dry very thoroughly
before cooking. They must be completely
dry.
Cut them more thinly. The maximum chip
dimensions are 13 mm x 13 mm.
(see cooking
Increase the amount of oil
table p. 13 to 14).
Clean the filter.
Reduce the amount of potatoes and adjust
the cooking time.
Comply with the maximum quantities
shown
on the cooking table.
Put the turn-over ring in place.
Reduce the amount of food.
Reduce the quantities.
Check that the paddle is correctly posi-
tioned, otherwise call the customer Helpline
below.
Observe the max level.
Do not use ActiFry for making recipes with
a high liquid content.
Plug the appliance in.
Close the lid.
Unplug the appliance, wait for 10 seconds,
plug the appliance in again and press
button. If the LCD screen still shows Er, see
the table of error codes p.17.
Call the customer Helpline below.
10
TABLE OF ERROR CODES: ER.
Er. 1 or 2 The fan is not working.
This error may appear if the
appliance has been stored
Er. 3 for a
long time at too low a
temperature.
Your appliance has a fault in
Er. 4
the temperature sensor.
The voltage of your domestic
Er. 5 network is too low. Cooking
performance may be altered.
The voltage of your domestic
network is too high; for safety
Er. 6 reasons your appliance should
be protected against the risks
of overheating.
ENVIRONMENT PROTECTION FIRST !
i Your appliance contains valuable materials which can be recovered or recycled.
 Leave it at a local civic waste collection point.
Check that all removable parts are
fitted and correctly positioned (bowl
ventilation output grid and removable
filter, pan, lid).
Check that there are no foreign items
in the removable parts.
After checking that there are no foreign
items in the ventilation outlets, if
the fault persists, call the customer
Helpline.
Leave the appliance at an ambient
temperature of more than 15°C for one
hour before starting it up again.
If the fault persists, call the customer
Helpline.
Call the customer Helpline below.
Contact your electricity supplier.
Contact your electricity supplier.
11
EN