Electrical Connection - S&P HA-600 N Notice D'installation Et D'utilisation

 Keep hot oil under control at all times to avoid it catching light.
 Although the appliance has a power switch, a single pole switch with a minimum gap of
3 mm between contacts and adequate for the total current must be fitted between the
appliance and the mains, in compliance with national regulations.
 This appliance can be used by children aged from 8 years and above and persons with
reduced physical, sensory or mental capabilities or lack of experience and knowledge if
they have been given supervision or instruction concerning use of the appliance in a
safe way and understand the hazards involved. Children shall not play with the
appliance. Cleaning and user maintenance shall not be made by children without
supervision.
 Children must be supervised to ensure that they do not play with the product.
 Before carrying out any maintenance or cleaning operations, always disconnect the
hood from the mains.
 When replacing bulbs always use bulbs of the same type and power, never more
powerful.
 If the cleaning operations are not done respecting the instructions indicated in
« OPERATION AND MAINTENANCE », there is risk of fire.
 Cleaning and user maintenance shall not be made by chlldren without supervision.
THE MANUFACTURER WILL NOT BE HELD LIABLE FOR DAMAGES TO PEOPLE
AND/OR PROPERTY DUE TO NON-COMPLIANCE WITH THESE WARNINGS.
2. INSTALLATION
The assembly and electrical connections should be carried out by a qualified technician.

2.1.- Electrical connection

The unit is of the double insulated
connection.
 Make sure the mains voltage and frequency coincide with those on the characteristics
plate on the hood and the remote extraction unit.
 The electrical connection must be carried out as follows:
Brown =
Blue
 Although this is a device with a switch, When installing the hood, it is advisable to fit it in
such a manner that the mains plug is accessible by the user. (Fig.2)
 In the case of direct connection to the mains, the installer has a connection strip inside
the terminal box at the end of power cable. To access it, remove the two screws and pull
the cover by a clip.
L (Line)
= N (Neutral)
12
, therefore does not require an earth