Installation; General; Fire Hazard - Hatco Krampouz KWM Série Manuel D'installation Et D'utilisation

English

General

Waffle Makers are shipped pre-assembled and ready for
seasoning prior to their first use. Care should be taken when
unpacking the shipping carton to avoid damage to the unit.
The following installation procedure must be performed before
connecting electricity and operating the unit.
WARNING
ELECTRIC SHOCK HAZARD: Unit is not weatherproof.
Locate unit indoors where ambient air temperature is a
maximum of 104°F (40°C).

FIRE HAZARD:

• Locate unit a minimum of 8" (203 mm) from combustible
walls and materials. If safe distances are not maintained,
discoloration or combustion could occur.
• Do not obstruct air ventilation openings on outer
housing of unit. Unit combustion or malfunction may
occur.
1. Inspect the shipping carton for obvious signs of transit
damage. If damaged, inform the freight company
immediately. CAUTION! Stop! Do not attempt to use
unit if damaged. Contact Hatco for assistance.
2. Remove the unit and any loose components/accessories
from the shipping carton. The following loose components
are included in every Waffle Maker (excluding models
KWMSL-4BR46 and KWMSL-2LG413):
• Handles
NOTE: To prevent delay in obtaining warranty coverage,
complete online warranty registration. See the
IMPORTANT OWNER INFORMATION section for
details.
3. Remove tape and protective packaging from all surfaces
of the unit.
• Make sure to remove all protective film from the stainless
steel surfaces.
4. Inspect the unit for freight damage such as dents in
housing or broken knobs. If damaged, inform the freight
company immediately.
Form No. KWMM-0220
Locate unit at proper counter height in an area that is
convenient for use. Location should be level and strong
enough to support weight of unit and contents.
Do not locate unit in an area subject to excessive
temperatures or grease from grills, fryers, etc. Excessive
temperatures and grease could cause damage to unit.
Damage to any countertop material caused by heat
generated from Hatco equipment is not covered under
the Hatco warranty. Contact manufacturer of countertop
material for application information.
5. Place the unit in the desired location.
• Locate the unit in an area where the ambient air
temperature is constant and a maximum of 104°F
(40°C). Avoid areas that may be subject to active air
movements or currents (i.e., near exhaust fans/hoods
and air conditioning ducts).
• Make sure the unit is at the proper counter height in an
area convenient for use.
• Make sure the countertop is level and strong enough to
support the weight of the unit and food product.
• Make sure all the feet on the bottom of the unit are
positioned securely on the countertop.
6. Install the handles into the waffle plates, if necessary.
• Thread a handle into the hole on the front of each waffle
plate. Tighten securely.
7. Make sure the drip tray(s) is in position on the base of the
waffle maker.
Drip
Tray
Handle
Base
Drip Tray
Installing the handles and drip trays
7

INSTALLATION

CAUTION
NOTICE
Hole
Drip Tray