Care And Cleaning - hestan KRPR36 Manuel D'utilisation

CARE AND CLEANING

EN
To clean the parts made of steel use a microfiber cloth and the sponge provided in the kit with
the appliance. Always use the cloth and sponge in the direction of the steel's satin finish.
Every now and then, to polish the steel, wipe with a slightly damp microfiber cloth.
Do not use the sponge on aluminum parts, such as the handles and the profiles of the glass
shelves.
You should use special care to keep the ventilation openings in the appliance or in the cabinet
that houses it free of obstructions.
Scrupulously follow the detailed directions that can be found in the provided kit and never
use abrasive or metallic products which could scratch and damage the satin finishing on the
appliance permanently.
Before performing any sort of cleaning, disconnect the appliance from the electrical power
supply.
Be careful not to damage the refrigerant circuit in any way.
CLEANING THE CONDENSER AND GRILL
Ventilation Grill
A ventilation grill is located either at the top of the
appliance or at the bottom according to the model type.
To clean it, use a vacuum cleaner with a soft brush
attachment at maximum power, sweeping it along the
vent slits.
In case of significant dust build up, the ventilation grill
can be opened or removed for more complete cleaning
and to clean the condenser.
Condenser
The condenser is located behind the ventilation grill.
Switch off the appliance by pressing the On/Off button
on the main control panel for about 3 seconds.
Wait about 30 minutes, until the finned condenser cools
down to room temperature.
On models with ventilation at the base, remove the grill
at the bottom (magnetically attached) and take it off.
On models with ventilation at the top, lift the grill as
shown in the picture. Thoroughly clean the grill and the
condenser fins by means of a vacuum cleaner with soft
brush attachment. Clean any dust build up thoroughly as
shown in the picture, taking care not to damage the fins.
Start up the appliance again, by pressing the On/Off
button
Clean the internal and removable parts by washing them
with a solution of lukewarm water, a small amount of dishwashing detergent.
Rinse and dry right away.
Do not use mechanical devices or other methods to speed up defrosting.
28
©2019 Hestan Commercial Corporation
on the control panel.
Do not bring cold glass parts into contact with boiling water. Do not
wash any parts of the refrigerator in a dishwashing machine since this
could damage or irreparably deform the parts.
The edges of the condenser are
sharp, therefore use adequate
protection for the hands and arms
when cleaning the condenser.
Do not use water on the electrical
parts, lights and control panel.