hestan KRPR36 Manuel D'utilisation page 7

SAFETY PRECAUTIONS - BEFORE YOU BEGIN
CLEANING AND MAINTENANCE OF THE ICE DISPENSER
Failure to properly sanitize the ice maker system can compromise the hygienic safety of the
water dispensed. Always follow sanitization instructions.
When using the appliance for the first time and every time the filter is changed, it is
recommended to let the water flow in the circuit using the "Manual Cleaning" function and
discard the ice produced in the first 24 hours. See "ACTIVATING THE ICE MAKER" on page
13.
Clean the ice bucket or drawer regularly using only drinking water.
The filter must be changed when indicated on the control panel or when the ice/water
dispenser has not been used for more than 30 days.
With each filter replacement, sanitize the ice and/or water distribution system using a food
grade disinfectant (with sodium hypochlorite), which does not alter the characteristics of the
materials. Run the "Manual Cleaning" function so that at least 1/2 gallon of water has come
through into the catch pan before use.
Only original spare parts supplied by the manufacturer should be used when replacing
components in the ice and water dispenser.
Any work on the appliance must be carried out by a qualified technician.
USING THE CONTROL MENUS
Depending on the appliance model, there may be one or two control panels, with various
controls available. Up/Down arrows
various cooling/refrigeration/freezer zones. When two panels are present, only the main
panel has the and
Many features and settings are only accessible through the control menus. Here are the basics:
1) Touch the button to activate the interactive menu system.
If the display shows "KEYPAD LOCKED", touch the
seconds. (See "UNLOCKING THE KEYPAD" on page 14)
• Either set of the up/down buttons
is always shown in the display.
2) Use the Up/Down buttons to show a selection, then touch the
• You may need to use the up/down buttons again to get to a final selection. When
turning selections ON or OFF, you will have to actually follow down to that ON or OFF
and touch to confirm it.
3) To go back out of the menu, touch the
See also: "SPECIAL SETTINGS AND FUNCTIONS" on page 14.
are provided to directly adjust temperatures in the
buttons.
will move the menu selections. The active selection
button as needed.
(CONT.)
and Down button for several
button to activate it.
©2019 Hestan Commercial Corporation
EN
5