Care And Cleaning - hestan KRP Serie Mode D'emploi

CARE AND CLEANING

To clean the parts made of steel use a micro ber cloth and the sponge
provided in the kit with the appliance. Always use the cloth and sponge
in the direction of the steel's satin nish.
EN
Every now and then, to polish the steel, wipe with a slightly damp
micro ber cloth.
Do not use the sponge on aluminium parts, such as the handles and the
pro les of the glass shelves.
You should use special care to keep the ventilation openings in the
appliance or in the cabinet that houses it free of obstructions.
Scrupulously follow the detailed directions that
can be found in the provided kit and never
use abrasive or metallic products which could
scratch and damage the satin nishing on the
appliance permanently.
Before performing any sort of cleaning,
disconnect the appliance from the electrical
power supply.
Make sure you do not damage the refrigerant
circuit in any way.
CLEANING THE CONDENSER
The edges of the condenser are sharp,
therefore use adequate protection for
the hands and arms when cleaning the
condenser.
Do not use water on the electrical
parts, lights and control panel.
Do not bring cold glass parts into
contact with boiling water.
Do not wash any parts of the
refrigerator in a dishwashing machine
since this could damage or irreparably
deform the parts.
26
©2018 Hestan Commercial Corporation
A ventilation grill is located either at the top of the appliance
or at th e bottom according to the model type.
To clean it use a vacuum cleaner with a soft brush attachment at
maximum power, sweeping it along the vent slits. In case of signi cant
dust build up, the ventilation grill can be removed to allow a more
accurate cleaning of the lter.
Switch off the appliance by pressing the Power button
the main control panel for approx 3 seconds.
Wait approx 30 minutes, until the nned condenser cools down to
room temperature.
On models with ventilation at the base remove the grill at the
bottom (magnetically attached) and take it off. On models with
ventilation lift the grill as shown in the picture.
Thoroughly clean the grill and the foam lter, by means of a
vacuum cleaner and the soft brush attachment.
Clean it thoroughly from any dust build up as shown in the picture,
taking care not to damage it.
Start up the appliance again, by pressing the Power button
the control panel.
Clean the internal and removable parts by washing them with a
solution of lukewarm water, a small amount of dishwashing
detergent.
Rinse and dry right away.
Do not use mechanical devices or other methods to speed up
defrosting.
on
o n