Special Maintenance; Programming The Parameters; Parameters Description; Refuse Disposal And Demolition - Keyfrost KBA Manuel

Special maintenance

6.
The instructions contained in this section are for qualified maintenance personnel.

6.1 Programming the parameters

(See paragraph 4.1.1)
The all parameters necessary for the correct operation of the machine have already been programmed into the control panel. In the
event that it becomes necessary to vary some of these parameters, follow the instructions given below:
Access to the programming mode is obtained by pressing down the SET button for more than 5 seconds. When PA1 appears on the
DISPLAY press SET again.
Using the UP and DOWN buttons to set the password (see technical documentation) and press SET.
Select the parameter to modify and press SET once more. Using the UP and DOWN buttons to set the desired value and confirm the
modification with SET.
To quit the programming mode press repeatedly FNC or don't press any buttons for at least 10 seconds.
To render the modifications to machine parameters effective, it is necessary to disconnect the machine from the mains power and then
reconnect it, using the selector switch or thermomagnetic switch. Parameters with previously set "default" values are shown in the table
(tecnical documentation).

Parameters description

6.1.1
See techinical documenation

Refuse disposal and demolition

7.
The instructions contained in this chapter are for qualified personnel. Disposal must be carried out in accordance with the standards in
force in the Country of use. The crossed-out wheeled bin means that within the European Union the product must be taken to separate
collection at the product end-of life. This applies to your device but also to any enhancements marked with this symbol. Do not dispose
of these products as unsorted municipal waste.

7.1 Refuse storage

As far as regards respect for the environment, there are different standards of reference in different countries. Provisional storage of
special refuse while awaiting disposal by definitive treatment and/or storage is permitted. Any type of refrigerant must not be disposed
of in the environment.
No replacement of refrigerant with refrigerants other than those specified on the data plate is permitted without prior authorisation from
the manufacturer.

7.2 Demolition procedures

For demolition procedures, the provisions set by the laws and relative bodies in the Country of use must be respected.
In general it is necessary to dispatch the appliance to qualified collection/demolition centres.
We suggest the following:
- Disconnect the appliance from the mains power and water supply.
- Dismantle the appliance, grouping the components according to their chemical nature.
- We remind you that the refrigerating system contains lubricating oil and refrigerant that can be recovered and re-used.
- Proceed to demolition of the appliance in full respect of the laws in force.
DEMOLITION OPERATIONS MUST BE CARRIED OUT BY QUALIFIED PERSONNEL.
26
Manual