Rear Panel Operation - Dometic SI 1500-12V Manuel De L'utilisateur

3.2

Rear Panel Operation :

3-2-1. Ventilation openings:
Do not obstruct, allow at least 25 mm for air flow.
3-2-2. Battery terminals:
Connect to 12Vdc/24Vdc battery or other 12Vdc/24Vdc power
source. On the inverter red (+) is positive, black (-) is negative.
Reverse polarity connection will blow the internal fuse and may
damage the inverter permanently.
3-2-3. RS-232C:
Connect for remote control unit (option accessory)
3-2-4. Connect chassis ground terminal to earth or to vehicle chassis
using 10 mm² wire.
WARNING !
Operation of the inverter without a proper chassis ground
connection may result in an electrical safety hazard.
Before proceeding further, carefully check that the Dometic
SI 1500 Sine Inverter is NOT connected to any batteries,
and that all wiring is disconnected from any electrical
sources. Do not connect the output terminals of the Dometic
SI 1500 Sine Inverter to an incoming AC source, it may
result in an electrical safety hazard and damage the
Inverter.
6