Special Instructions - Bodum 5500-2 Mode D'emploi

SPECIAL
INSTRUCTIONS
BEFORE USING
THE KETTLE
HOW TO USE THE
WATER KETTLE
POWER-SUPPLY CORD
A short power-supply cord is to be provided to reduce risks
resulting from becoming entangled in or tripping over a lon-
ger cord.
SWITCHING OFF THE KETTLE MANUALLY
The ON/OFF switch (3) can also be used to switch off the
kettle before the water boils.
SAFETY CUT-OFF
The kettle is protected against damage resulting from use
with an insufficient volume of water. A safety cut-off will
automatically disconnect the power supply if the heating
element overheats.
Should the kettle ever boil dry during operation, you must
leave it to cool for 10 minutes before re-filling it with cold
water. The safety cut-off will reset automatically once it has
cooled.
Clean the kettle before using it for the first time by filling it
completely (to the MAX mark) with water, boiling the water,
and then discarding the water.
FILLING THE WATER KETTLE
Remove the appliance body from the base unit (4).
Open the lid (1), fill with water and close the lid again.
Do not fill the kettle with less than the MIN mark and not
more than the MAX mark, to prevent the kettle from boiling
dry or boiling water escaping from the spout.
CONNECTION TO POWER SUPPLY
After filling the kettle, position it on the base unit (4). Ensure
that the kettle body is seated correctly on the contact unit on
the base unit (4).
Connect the mains plug to the power supply and press down
the ON/OFF switch (3).
Note: Ensure that the ON/OFF switch is able to move freely.
The kettle (0.5 and 1.0L) beeps when it gets plug into power
socket. The kettle (1.5l) doesn't beep when it gets plug into
power socket.
8
EN