ARIETE EVOLUTION 2.0 ROBOT 2712 Mode D'emploi page 29

b) Via charging station (I)
After installing the "Home Base" correctly,
place the Robot on this charging station,
making sure that the charge poles (S) meet
with the charge contacts (G) in the base.
The "Home Base" charge contacts are low
voltage and do not constitute any type of
hazard.
c) Auto-charge:
the Robot will automatically return to the
"Home Base" when the battery charge is
low.
To do this, it is necessary for the IR signal to
reach it from the "Home Base" which means
that the base must be in the same room as
the one being cleaned.
If the Robot is unable to return to the charg-
ing station at its first attempt, it will continue
to try to do so until it is correctly positioned.
Important!
The Robot cannot return to the charging station if the station is not connected to the
mains power; in this case, the suction function will be reduced until it runs out and the
Robot will switch off.
Important!
If the Robot is in a different room to the charging station, it will not be able to pick up
the recall signal.
Important!
Make sure that the power cord does not get in the way of the Robot, as there is a risk of
blocking the rotary brushes.
- 27 -
EN
Home
Base