General Notes And Use; Main Components; Technical Data - FAR RAC 171 Mode D'emploi

RAC 171

GENERAL NOTES AND USE

The tool must be used for rivets diam. 4.8 (aluminium excluded)
- 7.8 mm (aluminium only).
The riveting tool RAC 171 can also work with rivets type FARBOLT,
MONOBOLT® and MAGNA-LOK® 3/16" - 1/4" by previous
replacement of nozzles, cone and clamps. The RAC 171 oil
pneumatic system assures more power than the pneumatic system
used for other models. That means a reduction in the problems
due to the wear and tear of the components, therefore, there
will be an increase in reliability. The technical solutions adopted
reduce the dimensions and the weight of the tooi which, for these
reasons, make it very handy. The possibilities of leakage from
the oil-dynamic system, are eliminated by some sealed gaskets,
which solve this problem.

MAIN COMPONENTS

A) ...................................................................................... Nozzle
B) .................................................................Balancer connection
C) ................................................................................. Nails tank
D) ...............................................................Suction opening lever
E) ............................................................. Tensile strenght button
F) ............................................................................. Oil tank plug
G) ..................................................... Compressed air connection
H) ................................................................. Head carring nozzle
I) ......................................................................Protection bottom
A
56
Ø24
D
E
340
G
Ø145
Revision - 04
325
B
H
C
F
I
GB

TECHNICAL DATA

• Working pressure .......................................................... 6 BAR
• Min. int. diam. of the compressed
air feeding hose ........................................ min. diam = 8 mm
• Air consumption per cycle ............................................10.9 Lt.
• Max power ...................................................... 6 BAR-1750 Kg
• Stroke .........................................................................25.5 mm
• Weight ....................................................................... 2.930 Kg
• Working temperature ...................................................-5°/+50°
• Root mean square in total acceleration
frequency (Ac)
to which the arms are subjected ..........................16,7 m/sec2
AIR FEED
The air feed must be free from foreign bodies and humidity in order
to protect the tool from premature wear and tear of the components
in movement, therefore we suggest to use a lubrificator group for
compressed air.
HOW TO USE YOUR RIVETING TOOL (fig. f1-f2-f3)
WARNING!
Before using the tool, it is compulsory to fit the
nails tank (C) and the nails baffle (L).
Press lightly for assembling the nails baffle (L), as shown in the
figure f3.
After the clamping, the sheared nail is piped by the riveting tool and
ejected from the back. By swinging the lever (D) you can activate
the suction. By the suction nail system, the rivet remains in the
nozzle also turning over the head of the riveting tool downwards:
this detail increases a lot the usefulness of the riveting tool.
Do not keep the rivet with your fingers!
If you use the nails tank (C), when it is full of nails do not use the
Ø60
riveting tool. Disconnect the tool, unscrew the nails tank (C) and
empty it properly. DO NOT DISPERSE ANY NAIL! Screw the nails
tank (C) and start again to work.
f1
D
Date 09-2008 9