General Description - Urmet 1068 Livret D'instructions

ENGLISH

GENERAL DESCRIPTION

WARNING! This document provides only some essential product information. Refer to 1068 series control
panel manuals for more detailed information.
The module Ref. 1068/458 can be used to connect 1068 control panels to the GSM e/o GPRS telephone
network for sending event notifications in voice or data format (IDP, IDP/IP, SMS protocols) and for the
remote system management by means of a telephone call with vocal menu.
The module is provided with two-band (900/1800 MHz) GSM/GPRS transceiver and it is fitted with an
antenna to be inserted inside control panel. The module implements a vocal synthesis function for reading
the messages used in the remote management speech menu and for notifying events by speech calls.
Should control unit position prevent GSM/GPRS module from receiving a sufficient field coverage,
1067/014 antenna (not provided in the supply) can be used.
WARNING! Urmet accepts no responsibility for lack of availability, whether temporary or permanent, of
GSM/GPRS cellular transmission network possibly conditioning calls made and programmed messages sent.
INSTALLATION
WARNING! The connection of the GSM/GPRS module and inserting/removing of the SIM Card
must be performed at the unpowered control panel (network and battery disconnected).
NOTE: Before opening the control panel enter the maintenance process in order to avoid the sirens to sound.
1. INSERTING GSM MODULE INTO CONTROL PANEL
The GSM / GPRS module is mounted on the mother board of 1068 series control panels.
For installing the module:
 Insert the two support spacers supplied into the holes (D) located on the motherboard near the bottom
right corner of the area occupied by the module (Fig.1). The spacers (D) must be inserted with the
spring-mounted support tab resting on the motherboard.
 Insert the module into the respective connector as far as it will go and the spacers (D) previously inserted
on the motherboard into the holes (A) on the module.
2. INSERTING ANTENNA
Insert GSM antenna provided in the supply into the special seat of control panel base (right side – Fig.2).
WARNING! You are recommended to tighten firmly the antenna SMA connector set on the interface,
but without damaging it (tightening torque: 0.9 Nm).
3. INSERTING SIM CARD
 Open the SIM door cover by sliding it in the direction indicated by the OPEN arrow and then open the
door.
 Insert the SIM in its housing, with the gold contacts facing inwards.
 Close the cover and lock it as indicated by the LOCK arrow.
 Check / disable the PIN and all services enabled on the SIM card.
WARNING! There are different SIM card types: with 5 volt power supply (now obsolete), with 3 volt power
supply and with 1.8 volt power supply (the most popular, now available on the market). 1068/458 module
only manages 1.8 volt and 3 volt power supply SIM cards currently available on the market. Should you
have any doubts, please contact your telephone provider to learn about the type of the SIM card that is in
your possession.
2 DS1068-014A