Troubleshooting - SilverCrest SIKP 3400 A1 Mode D'emploi

Troubleshooting

PROBLEM
The appliance does not
function. The control lamp
On / Standby r does not
glow.
The appliance does not
start the cooking process.
E01 appears in one of the
displays.
E02 appears in one of the
displays.
E03 appears in one of the
displays.
E05 appears in one of the
displays.
E06 appears in one of the
displays.
E07 appears in one of the
displays.
SIKP 3400 A1
POSSIBLE CAUSE
The plug is not connected.
The appliance is damaged.
There is no cookware on
the respective cooking area
1 2 4.
The cookware is not suitable
for induction cooking areas.
The appliance is not being
supplied with enough voltage
(< 160 V).
The appliance is being
supplied with too much
voltage (> 270 V).
There is a short circuit inside
the appliance!
The appliance is too hot
(in power levels mode)!
The temperature sensor under-
neath the cooking area 1 2
4 is defective or there is a
short circuit..
The appliance is too hot
(in Temperature-Mode)!
POSSIBLE
SOLUTIONS
Connect the appliance to
a mains power socket.
In this case, contact
Customer Services.
Place suitable cookware on
the cooking area 1 2 4.
Use suitable cookware
(see chapter "Suitable
Cookware").
Check to ensure that the
appliance is connected to
a properly installed mains
power socket supplying
220 - 240 V ~ , 50 Hz.
Check to ensure that the
appliance is connected to
a properly installed mains
power socket supplying
220 - 240 V ~ , 50 Hz.
Immediately disconnect the
plug from the mains power
socket and contact the Cus-
tomer Services department!
Disconnect the plug from
the mains power socket
and wait until the appliance
has cooled down.
Disconnect the plug from
the mains power socket
and contact the Customer
Services department.
Disconnect the plug from
the mains power socket
and wait until the appliance
has cooled down.
GB
77