8.1. CONNECTING CONNECTOR
A connector is used to connect the device to the voltage mains.
ALWAYS USE THE MAIN SWITCH TO ISOLATE THE POWER SUPPLY
01
Unlock the connecting part.
04
Turn the core.
07
Insert the cable through the cable gland
up to the core.
10
Slide the core into the housing and
tighten it.
13
Place the 2 sides together.
56
02
Pull the 2 parts apart.
05
Remove the core from the housing.
08
Connect the cables correctly to the core.
11
Fix the cable gland.
14
Tighten the connecting part.
03
Place the tool on the connection core.
06
Loosen the cable gland.
09
Fix the cables by tightening the screw.
12
Tighten the cable gland with 2,4/4 Nm.