Volvo Penta D130 Mode D'emploi page 5

I I I I I N N N N N S S S S S TR TR TR TRU U U U U C C C C C TI TI TI TI TIO O O O O N FO N FO N FO R F R FI I I I I N N N N N E AD R F
TR N FO N FOR F R F
(Intended for twin installation, carry out as necessary)
Setting step
System voltage on,
press pin B
Remove pin B
Press pin B
*
Remove pin B
Press pin B
*
Remove pin B
* = I * = I * = IM M M M M P P P P P O O O O O RT RT RTANT W RT ANT W ANT Wait for 10 seconds ANT W
* = I * = I RT ANT W
with the unit connected to system with the unit connected to system with the unit connected to system
with the unit connected to system with the unit connected to system
volt volt volt volt voltage to confirm the code setting. age to confirm the code setting. age to confirm the code setting. age to confirm the code setting. age to confirm the code setting.
This figure shows the difference in percent of current
scale value. The step between the figures is 0.5.
E AD E ADJ J J J J U U U U U S S S S S TM E AD TME E E E E NT TM TM NT NT
E AD TM NT NT
ait for 10 seconds ait for 10 seconds ait for 10 seconds
ait for 10 seconds
Shown on display A Descriptions
A = Fine adjustment
mode
Displays the current dif-
ference to normal setting.
Display increments, dis-
play shows current differ-
ence to normal setting
Displays the current dif-
ference to normal setting.
Display decrements, dis-
play shows current differ-
ence to normal setting
Displays the current dif-
ference to normal setting.
Switches to hours
counting