Installation; Clearance And Positioning - Omcan CE-IN-3232 Manuel

Installation

• NO ATTEMPT SHOULD BE MADE TO OPERATE THIS APPLIANCE DURING AN ELECTRICAL
POWER FAILURE. In the event of the loss of electrical power, exhaust hood will not function. If this
happens turn off the hood power switch and turn off the gas tandoor oven valve(s).
• IF INSTALLATION SITE IS PROVIDED WITH A POWER LOSS INTERLOCK DEVICE, IT WILL ACT TO
SHUT OFF ALL GAS IN THE EVENT OF ELECTRICAL POWER FAILURE. FOLLOWING LOSS OF
POWER MANUAL RELIGHT OF PILOT BURNER WILL BE REQUIRED.
• Refer to local codes for the building fresh air supply requirements. For the U. S. A., in the absence
of local codes, refer to the National Ventilation Code entitled, "Standard for the Installation
of Equipment for the Removal of Smoke and Grease laden Vapors from Commercial Cooking
Equipment", NFPA-96-latest edition.
• Note: Where servicing may require greater access clearances than those shown on the name plate,
then the greater clearances should be allowed for.
• At installation, adequate clearances should be provided for proper operation and servicing of
the appliance and any field installed optional items. Data plate applies only to tandoor oven as
provided by appliance manufacturer.
• This appliance is for installation only at the clearances indicated on the name plate. Clearances are
specified from combustible and for non-combustible construction.
• Observe clearances from combustible surfaces as marked on name plate. Clearances posted on
unit are for safety reasons and lesser clearances cannot be applied. Additional clearances might be
required for service and operator access.
• Do not block any louvered openings on appliance service panels.
UNPACKING
• Un-crate the unit with extreme care, do not use a hammer or heavy tools to un-crate the unit. Always
remove shipping container parts and panels by only outward prying.
• Make sure the unit is in the upright position before starting to un-crate.
• Before fixing the appliance in place, remove all protective plastic coating from the unit.
• Oven is on 6" (152mm) wheel castors and can be rolled out easily to the designated installation area.
• Unit must be rolled around by hand. Do not use a lift jack.

CLEARANCE AND POSITIONING

• This appliance requires a 6" (150mm) clearance from combustible and non-combustible material and
surfaces.
• Never install propane appliances below grade.
• A clear space, (rear clearance) of at least 6" (150mm) should be maintained at the rear and sides of the
appliance.
• There must be minimum clearances of 32" (813mm) between top of the appliance and any overhanging
shelf. Shelves must be of non-combustible material.
• It is recommended that the appliance is not installed in draughty locations or near doors.
• If the appliance is positioned on a combustible floor, sheet material (preferably stainless steel) equal to the
base area of the appliance must be secured to the floor prior to fixing the appliance in place. NOTE: For
Canadian and U. S. A. installation is authorized only on non-combustible floors.
• Ensure that the appliance is level.
8