Technical Specifications - Omcan CE-IN-3232 Manuel

Masquer les pouces

Table Des Matières

Table des Matières

Les langues disponibles

Model

Mouth Diameter

Heat Input

Inlet Gas Pressure

Maximum Inlet Gas

Pressure

Minimum Inlet Gas

Pressure

Manifold Pressure

Dimensions

Item Number

BEFORE STARTING WITH THE INSTALLATION OF THE APPLIANCE, PLEASE READ

AND BE FAMILIAR WITH THE INFORMATION IN THIS MANUAL

Installation of this must be performed by a registered gas – safe gas fitter or in the U.S.A, a qualified installer.

•

Appliance installation sites should be provided with safety instructions based on information

supplied by local fuel suppliers. These instructions are to be posted in a prominent area near the

appliance.

•

All installations are to conform to local codes. In the absence of local codes, installation should

conform to the National Fuel Gas Code, ANSI Z223.1/NFPA 54, and in Canada the National Gas

Installation Code, CAN/CGA-B149.1.

•

The appliance and its individual shutoff valve must be disconnected from the gas supply piping

system during any pressure testing of that system at pressures in excess of psi (3.45 kPa).

•

The appliance must be isolated from the gas supply piping system by closing its individual manual

shutoff valve during any pressure testing of the gas supply piping system at test pressures equal

to or less than 1/2 psi (3.45 kPa). In Europe a gas soundness test must be carried out.

•

Oven is to be castor mounted for use: The installation shall be made with a connector that complies

with the Standard for Movable Gas Appliances, ANSI Z21.69 CSA 6.16, and a quick disconnect

device that complies with the Standard for Quick-Disconnect Devices for Use With Gas Fuel, ANSI

Z21.41CSA 6.9. Adequate means will be provided on site to limit the movement of the oven without

depending on the connector and the quick-disconnect device or its associated piping to limit the

appliance movement. All castors are fitted with brakes to limit the movement of the tandoor.

•

Do not allow untrained operators to use this equipment.

•

Exercise extreme care in handling metal parts. Do not touch any metal or other surfaces that

become hot in operation.