Replacement Parts - Omcan CE-IN-3232 Manuel

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Maintenance
CHECK TO ENSURE THE BURNER HAS A GOOD FLAME EACH TIME IT IS TURNED ON.
WARNING: Components after cleaning should be replaced in reverse order of removal and verified to
be correctly positioned before Tandoor is fired. If any parts are damaged or lost during cleaning, do not
operate unit until they are replaced. To do so will void warranty.

Replacement Parts

CODES FOR REPLACEMENT PARTS
68120 - LID FOR 28 X 30 INCH TANDOOR OVEN
68162 - LID FOR 32 X 32 INCH TANDOOR OVEN
68163 - LID FOR 34 X 34 INCH TANDOOR OVEN
68122 - EXTRA CLAY (PER PACKET) FOR TANDOOR OVEN
68123 - CLAY BALLS (SET OF 30) FOR TANDOOR OVEN
68124 - SKEWERS (SET OF 12) FOR TANDOOR OVEN
68125 - GADDI FOR TANDOOR OVEN
68126 - TAWA HOT PLATE FOR 28 X 30 TANDOOR OVEN
68869 - TAWA HOT PLATE FOR 34 X 34 TANDOOR OVEN
68871 - TAWA HOT PLATE FOR 32 X 32 TANDOOR OVEN
68127 - 9 INCH GAS BURNER FOR TANDOOR OVEN
68128 - 10 INCH GAS BURNER FOR TANDOOR OVEN
68129 - 12 INCH GAS BURNER FOR TANDOOR OVEN
68130 - COMPLETE SAFETY VALVE KIT FOR TANDOOR OVEN
68132 - 2.95MM JETS/INJECTORS FOR TANDOOR OVEN
68872 - 3.5MM JETS/INJECTORS FOR TANDOOR OVEN
68873 - 4.2MM JETS/INJECTORS FOR TANDOOR OVEN
1. Only qualified persons should conduct service or repair of this equipment.
2. Always disconnect power and fuel when repairing or servicing these appliances.
3. Any service or repair conducted on the unit as covered by the warranty has to be authorized by the
manufacturer.
4. Only the original factory parts are to be used for any repair or replacement.
5. If parts are lost or missing, obtain and install replacement parts before returning unit to service.
6. Following service, be sure to reconnect all parts, and close all panels and covers before power is turned
back on. Do not attempt to bypass any safety controls. Doing so voids warranty and creates dangerous
operating conditions.
7. Access to service most components is gained by removing of the front cover. This is done by undoing the
screws which secure the front cover and then removing cover.
14

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Ce-in-3434Ce-in-2830

Table des Matières