Frothed Milk - Krups EA88 Série Mode D'emploi

Preparing other drinks:
THE "ONE TOUCH CAPPUCCINO" ACCESSORY
This "One Touch Cappuccino" accessory enables the preparation of one or two
cappuccinos or cafe at the same time.
CAPPUCCINO/LATTE
– Preparing your appliance:
Connect the milk suction pipe on the left to the "One Touch Cappuccino" block. Place the
other end in a container filled with milk Fig. 11. You can prepare one or two cups with your
appliance at the same time.
Position your cup or cups and set the button on the block to the desired position:
cappuccino or latte Fig. 12.
– Settings and making drinks
Press the "Cappuccino Latte" button (1 cup) or the "Cappuccino x 2" button (2 cups).
All settings can be adjusted to your taste.
For each cappuccino, the machine will take into account the last settings you used.
Once the settings have been set, press OK.
The steam is used to froth the milk. As the production of steam requires a high temperature,
the appliance has an additional pre-heating phase.
The following steps are automated sequenced: frothing of the milk, grinding of the coffee
and preparation of the coffee.
Your drink is ready for you to enjoy Fig. 13.

FROTHED MILK

– Prepare your Appliance
Attach the milk suction pipe on the left-hand side of the "One Touch Cappuccino" block.
Place the other end into a container filled with milk Fig. 11.
Position the cup or cups and select cappuccino using the appliance's button. The steam is
used to froth the milk. As a higher temperature is required when producing steam than when
making an espresso, the appliance will launch an additional pre-heating phase.
Select the Frothed Milk recipe on the screen. You can customize the frothing duration using
the menu. You can change it using the + or – buttons, then press "OK" The last frothing
duration selection will be memorized for the next recipe.
RINSING THE "ONE TOUCH CAPPUCCINO" BLOCK
We advise you to rinse the "One Touch Cappuccino" block after every time you make a
milk-based recipe.
At the end of the preparation, an alert appears on the screen to remind you.
To start rinsing, simply press the alert pictogram. If not, it will be carried out automatically
when the coffee maker is switched off at the time when you decide to switch it off.
You can also start the rinsing through the maintenance menu. To do this, press the "Prog"
button ==> "Maintenance" ==> "Accessory rinsing".
HOT WATER
Select the Hot Water recipe on the screen. Place the cup(s) under the coffee outlet.
You can change the height of the coffee outlet to suit the size of your cup or cups. Fig. 10.
You can change the quantity using the + or – buttons. Press the "OK" button to start the
preparation.
You are still able to increase or decrease the amount of water for your drink during its
preparation.
13