Table des Matières
Publicité
PACKING LIST
PART NAME
Pressure Washer
Trigger Assembly
Spray Wand
Soap tank
Handle
Green - Narrow fan tip (25° )
White - Wide fan tip (40° )
Spray Tip Cleaning Tool
Screw
Operator's Manual
Quick Start Guide
FIGURE
Installing the wheels
WARNING:
This Quick Start Guide is not a substitute for reading the operator's manual. To reduce the risk
Set-up
Insert the axle through the wheel.
of injury or death, user must read and understand operator's manual before using this product.
1
Connect garden hose to pressure
Slide the washer over the axle pass the pin hole.
washer water intake.
Insert the axle and wheel through the frame. Slide the washer
over the axle and insert the pin through the hole to firmly fasten
the wheel assembly.
1800 PSI / 1.1 GPM
2
Assemble pressure washer gun to spray wand.
Wheel
ELECTRIC PRESSURE WASHER
GPW 1800
USING DETERGENT
Put pressure washer detergent in detergent tank.
3
Connect desired pressure tip.
Axle
Washer Pin
Install blue or black soap nozzle.
Installing the gun holder
Squeeze trigger and wait approx.1 minute for soap.
Line up the screw sleeves with the holes in the upper handle
and push through.
4
screwdriver (not included) until the screw is tight.
Insert the screw and turn clockwise with a Phillips head
Insert high pressure hose into trigger
handle.
SPRAY TIP
SPRAY TIP APPLICATION
Red - Stream tip (0° )
The red 0 degree tip provides a straight line of spray. It provides the highest
5
Connect the high pressure hose to the
water outlet connector.
0
O
amount of pressure. It is best used for removing hard, stuck-on grime or dirt.
Green - Narrow fan tip (25° )
The green pressure washer tip provides high versatility with its 25 degree angle tip.
25
dirt from surfaces, but is designed to not damage many surfaces. This pressure
Referred to as the washing tip, because it provides adequate pressure to remove
6
Turn on water at outlet.
O
washer tip is designed for "sweeping" foliage or debris given its wide angle. This tip
is versatile due to its wide area of cleaning and strong pressure application.
White - Wide fan tip (40° )
Installing the upper handle
Push and hold the push-pin buttons on the sides of the upper
The white 40 degree tip, referred to as the "fan" tip creates the widest area of
cleaning with relatively low pressure. This pressure washer tip is best used for light
7
Run water hose for 30 seconds with the
handle assembly (1) as you slide the handle onto the frame (2).
40
O
decks and other soft or delicate surfaces.
or delicate cleaning applications. It is recommended for light cleaning on wood
motor in OFF position. This helps drain air
from the tank and lines.
(1)
30
S
The black soap spray tip, is used for soap application. Soap is applied under low
Black - Soap spray tip
8
Connect power cord to wall outlet
Push-pin
(2)
SOAP
pressure high volume for optimum performance. Soap cannot be applied under
Extension cord not recommended.
high pressure with this machine.
Turbo Nozzle Tip
9
Turn on Pressure Washer
The nozzle rotates in a zero to 15 degree spray pattern in a circular motion to
break down tough dirt and grime. The spray pattern can cover area of 4 to 8 inches
IMPORTANT: Ensure water outlet is On
wide, depending on a distance between the tip and the surface being cleaned.
to the pump.
before turning power On to avoid damage
NOTE:
Missing parts, accessories or need a service center?
AUTO ON/OFF SWITCH: This Pressure washer is equipped
Do Not Return to Store
with an Auto Start/Stop feature.
To operate: Turn the power switch to the On (I) position.
Call : 1-888-909-6757
Pump will pressurize and shut down immediately.
www.GreenWorksTools.com
Once the trigger of the gun is depressed the unit will turn on.
Unit will shut off and be in standby mode when trigger is
Rev:02
released.
10
PART NO.
1
1
1
1
1
1
1
1
2
1
1
Publicité
Chapitres
Table des Matières
Dépannage
