Fein ASg 636 Kinetik Mode D'emploi page 11

ASg(e) 636 - Buch Seite 11 Mittwoch, 14. März 2001 10:40 10
ASg 636 Kinetik / ASge 636 Kinetik
Please hand these operating instructions
to the repair centre. An overview of spare
parts can be found at the end of these
operating instructions.
Upon request a repair manual is sent to
the electrical engineers.
Only use original FEIN spare parts.
Maintenance work.
For stationary application using a drill
stand, remove the power tool from the
drill stand after every 50 hours of oper-
ation while it is warm, and for lubricat-
ing the motor and gears evenly, turn
the power tool through 180° and
switch it ON.
Spare parts.
The overview of spare parts is at the end
of these operating instructions. Quoting
the parts no. (1), order no. (2) as well as
the number of spare parts (3) facilitates
the ordering procedure.
Accessories.
Illustrations and order numbers can be
found at the end of these instructions.
Description of the accessories:
A Collet chuck with collet 3.5/4.5/6 mm.
B Floating collet chuck with collet
3.5/4.5/6 mm.
C Jaw chuck with key.
D Floating collet chuck with key.
E Wedge drifts (2 pieces) for removing
the clamping chuck.
F Bit stop.
G Collet for collet chuck and floating
collet chuck.
H Thread cutter with curling cut for
through-holes.
I Thread cutter with right-handed helical
grooves for blind holes.
J Rotary blow roller coupling for sink-
ing screwed inserts and stud bolts
(up to M 12) and also for cutting
threads in blind holes without a bit
stop (M 4 – M 8).
K Quick-changing chuck for rotary blow
roller coupling. Inner cone B 12, tool
holder with 11 mm hexagonal recess.
Accessories for sinking screwed inserts
according to DIN 7965 (pipe couplings,
screwed dowels):
L Tool holder.
M Sinking tool.
N Bit stop.
O Metal carry case
(390 x 240 x 110 mm).
Guarantee.
FEIN power tools are guaranteed in
accordance with statutory and national
regulations (evidence of purchase by
invoice or delivery note).
Damage caused by improper handling,
overload or normal wear shall be
excluded from the guarantee.
Please contact our customer service
(repair centre), FEIN authorized service
centres or agencies.
Environmental protection.
Packaging, worn out power tools and
accessories should be recycled.
Further information is available from your
dealer.
EN
11