pclocs iQ Wall Cages Manuel D'utilisation page 3

STEP 3. Attach SCB in right iQ Wall Cage and rout cables.
• Insert power cord through the right grommet in the iQ Wall Cage.
• Hang the iQ 16 SCB on screws using key-holes. Plug power cord into the iQ 16 SCB.
• Plug in USB 'B' (host) cable into the iQ 16 SCB and run cable along the cavity to exit with the power cord.
STEP 4. Rout 8 USB cables from the left iQ Wall Cage to the iQ 16 SCB.
• Draw the 8 USB plugs though the slot in the top of the rear panel.
• Rout the cables through the left hole. Attach the USB cables to the 8 (left) ports of the iQ 16 SCB.
• Hang the other ends of the USB cables on the cable-hooks allowing approximately 150mm of cable to
hang down.
INSTRUCTION MANUAL