pclocs iQ Wall Cages Manuel D'utilisation page 2

iQ Wall Cages™
Follow these instructions for easy and fast set-up of your iQ Wall Cages.
PC Locs, LocknCharge and the Padlock device are Trademarks of IWS Global Pty Ltd.
Disclaimer.
This information is the intellectual property of IWS Global Pty Ltd and may not be distributed, duplicated
or copied in part or full without the written permission. Since the use of this information, the equipment
connected and the conditions by which any IWS Global product is used is beyond the control of IWS Global,
it is the obligation of the owner and/or user to determine the correct and safe use of any equipment and
product. To the extent that the law permits, any liability which may be incurred as a result of the use or
future use of a product manufactured or sold by IWS Global is limited to the cost of repairing or replacing the
failed product or component at the discretion of IWS Global either within, or outside of warranty periods,
and does not extend to any loss or damage which may be caused as a consequence of misuse or failure of
the equipment or product or the information contained herein. IWS Global shall not in any event be liable for
economic loss of profits, indirect, special, bodily injuries or consequential damages.
STEP 1.
• Un-pack the iQ Wall Cages and accessories:
• Wall Cages, Baskets for carrying devices and iQ 16 SCB Sync Charge Box (iQ 16 SCB).
STEP 2. Join two iQ Wall Cages together using 5mm screws.
• Firstly, remove the grey rubber grommets between the adjoining sides.
• Insert one screw from the left and the other from the right and tighten using a phillips head screw driver.
• Slit grommet along grooves with a sharp knife.
Congratulations on your purchase.
Copyright IWS Global Pty Ltd, May 2014.