Spark Plug Maintenance; Fuel System Maintenance - LIFAN Power USA ENERGY STORM LF3500 CSA-CA Manuel D'utilisation

SPARK PLUG MAINTENANCE:

1. Remove Spark Plug Cap (refer to "Spark Plug Cap Removal" figure below.)
2. Remove Spark Plug with socket and handle supplied with your unit (refer to "Spark Plug Removal"
figure below.)
3. Clean any carbon build-‐ ‐ up around the Spark Plug.
4. Check the Spark Plug Gap and adjust if necessary. 0.30-‐ ‐ inch gap.
5. Lubricate the threads of the Spark Plugwith anti- ‐ ‐ seize compound or engine oil.
6. Re-‐ ‐ install the Spark Plug and Spark Plug Cap.
Spark Plug Cap Removal

FUEL SYSTEM MAINTENANCE:

NOTE: Periodically you can get sediment or trash in your Carburetor Bowl. Use the following procedures to
clean:
1. Turn the fuel cock (valve) to the "OFF" Position.
2. Remove the carburetor bowl by removing the mounting bolt located at the bottom of the bowl.
3. Dump out the old fuel and sediment into an approved container and clean carburetor bowl
thoroughly.
Maintenance
Spark Plug Removal
29