STARTING THE ENGINE:
1. Unplug all electrical loads from the generator.
2. Make sure the generator is in a level position.
3. Open the fuel cock by turning the fuel cock to the "ON" position.
4. For cold engine starts only: Pull the choke pin to the engaged position per the instruction
label on the generator main frame.
PULL START (RECOIL) ONLYMODELS:
5. Place the On/Off switch in the "ON" (l) position.
6. Grasp starter handle and pull slowly until resistance is felt. Then pull the cord rapidly with a
full arm stroke. Allow the rope to return slowly. Do NOT allow the rope to snap back against
housing.
7. Once the engine runs for 3-‐ ‐ 5 seconds, push the choke pin in to disengage.
Operation ofGenerator
HOW TO USE YOURGENERATOR
Refer to the Controls and Featuressection.
21