OIL CHANGE PROCEDURES:
engine oil should be performed after each 40 hoursof use of you Power Equipment Product. Check your engine
oil level prior to each use.
1. Start your engine and let it warm up to get the oil warm and thinner. Turn the engine On/OFF switch to
the "OFF" position. Turn Fuel Valve to the"OFF" position.
2. Remove the oil cap/dipstick by turning counter clockwise. Remove the oil drain plug located below the oil
cap/dipstick utilizing the appropriate tools.
USE CAUTION: THE OIL MAY BEHOT.
3. Drain the engine oil into an approved receptacle and discard in accordance with all Federal and State
Regulations. Never dump the used engine oil on the ground or into drains, only discard in an approved
manner. Check with your local authorities to determine the regulations in your area.
Maintenance
Refer to Controls and Feature section for diagram. Periodic Maintenance of your
26